Delphi SA10116 - XM Satellite Radio Signal Repeater Guia do Utilizador descarregar pdf (Página 11)

Getting Started

Power Up the System

Use the power button on the receiver or on its remote control to turn on

the receiver. If the display reads “ANTENNA” after powering up, check that

the antenna connection is secure and completely pushed in. Next, change

channels (from 0 to 1 or from 1 to 0 if the receiver is not authorized yet).

NOTE: Some receivers will power up automatically when installed in the

Delphi Premium Sound System.

If the “ANTENNA” message remains, power down the radio, unplug

the antenna and look for any obvious damage in the connector, jack or

antenna cable. If no damage is detected, reconnect the antenna, turn the

unit back on, and change channels again. If the message still appears,

contact your retailer.

If the display reads “NO SIGNAL” after powering up, follow the instructions

in “Setting up the Antenna” on page 5.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

Sem comentários

Delphi SA10116 - XM Satellite Radio Signal Repeater Guia do Utilizador Página 11